Industry news

Reasons for abnormal reset of laser cutting machine

2020-06-23
1. The X-axis and Y-axis movement directions of the laser cutting machine are in the opposite direction, and hit the side end. In this phenomenon, check whether the parameters of the main board are wrong, and stop to check whether the parameter settings of the main board are wrong.
2. The control panel of the laser cutting machine displays normal, and the X axis and Y axis do not move. You can try to unplug the sensor terminal of the motherboard to see if the machine is moving. In this case, you should consider replacing the sensor.
3. The beam is reset normally, the X axis of the laser cutting machine is not reset, and the motor wire or the motor shaft may be broken. In this case, the motor wire or the small motor should be replaced.
4. The direction is correct when resetting, but the X-axis or Y-axis cannot be stopped when the apex is reached (check the motherboard parameters first). If it is correct, check the motherboard or the sensor for this phenomenon and replace it.
86-531 88692337
  • E-mail: export05@mornlaser.com